Comparison between non photo catalyst and photo catalyst

Non photo catalyst test data
Nest peace=30mm dipped paper honey-comb

1st Time

Time (minutes)

Deodorized
Ratio (%)

0
30

Ammonia

23
9
60.9
Acetoaldehyde
10
6
40.0

Acetic acid

4.5
0.1
97.8
Total Ability : 59.7

Photo catalyst (Titan oxide) test data
Test peace : 30mm paper honey-com

1st Time

Time (minutes)

Deodorized
Ratio (%)

0
30

Ammonia

40
20
50.0
Acetoaldehyde
14
12
14.29

Acetic acid

8
0.5
93.75
Total Ability : 43.08

Deodorizing Test

Deodorizing Test
For hydrosulfate, it is decreased 1 by 300 of the concentration after 2 hours with coated ECOKIMERA(R) S against no changed with not coated one

Test method: Injected 3 litters of sample gas in 5 litter Tedoler bag. Then ECOKIMERA(R) treated and blank test peace put into them.

Deodorizing Test for Acetoaldehyde
Temperature 30C Humidity 65% Room light Formaldehyde

 

Applied amount
cc/m2

Initial conce ntration/ppm

2 hours later
concentration/ppm

Deodorized Ratio/%

Polyurethane foam

20
113
29.0
74
Cotton cloth
20
15
1.6
89

Polyester Cloth

20
15
8.0
46
Polyacrilate Cloth
20
15
8.5
43
Polyurethane sheet
20
15
8.4
44
Ply-woods Veneer board
20
15
8.4
44
Wall Paper
(Vinyl Chloride in it)
20
15
8.0
74

Deodorizing Test result

Picture of surface

Application

Application facts

Notice on coating

  • Do not use spray gun except exclusive one.
  • Do not put excess amount of the solution into the bottle of spray gun for one use.
  • After using the exclusive spray gun, it should be washed and cleaned for next using.
  • The spray gun and bottle should be completely dried and used.
  • Do not apply ECOKIMERA on seat of leather.
  • Keep 30cm of distance spraying nozzle and object to be applied. Especially for window glass,
    electric devices such as audio systems and handle of the car, to keep the distance is important.
  • White stains may be observed on the substrates by applying from short distance. In this case clean them off immediately. It would be quite difficult to remove them out after drying.
  • Do not add new solution to remain in the bottle for next use. It may cause precipitation in the solution.
  • A precipitation in the solution during strage does not give any effects on the function.

Application facts